Ideally, RejeX should be applied to a cool, dry, clean surface.
When over 30° C, be sure to apply RejeX out of direct sunlight. If the surface is too hot, the coating can cure before it has properly bonded to the surface, so it may not perform up to its potential.
RejeX is wiped on, allowed to dry to a haze for approximately 20 minutes, wiped off, then allowed to cure for 8-12 hours (depending on the humidity; the higher the humidity, the faster the cure). Curing is required to allow the monomers (polymer building blocks) that make up RejeX to attach to the surface being treated and to cross-link into a crystal-clear, impervious film.
It is important to allow RejeX to cure for 8-12 hours after the haze has been wiped off. If the coating is exposed to contaminants such as oil, fuel, soot, hard water, tree sap, cleaners, etc. before it has cured, the contaminants may interfere with or embed in the protective film.
RejeX can be applied in multiple coats, allowing 8 hours curing time between coats for deeper color and greater depth of gloss.
RejeX is not meant to be used on porous surfaces, highly oxidized painted surfaces, or to fill fine scratches.
